Sandblasting Cabinet Blasting Pot And Sandblaster Parts

Electrostatic Powder Coating Machine

Short Description:

  • With flat and smooth appearance and workpiece with no deep corners.
  • High sensitivity and durability.
  • Thickening resistance to puncture the tip, the low maintenance rate.
  • With circuit protection, voltage self-adjusting function, to ensure a perfect spraying effect.
  • High voltage module near the nozzle, low voltage loss, replaceable high voltage components to bring convenience to the maintenance.
  • Large flow of pneumatic components, in the smaller air pressure, can still achieve higher powder.
  • All stainless steel for powder cartridge, can not use tools to easily remove all parts and clean.
  • Two central gas design, so that the needle is no longer needle-guided fluid powder, to enhance the discharge effect, improve the rate of powder.
  • Rotating atomized air flow is greatly improved coating quality.

Product Detail


Product Tags

Electrostatic spray machine works:
Electrostatic powder coating equipment (electrostatic spray machine) the powder coating to the surface of the work

under the action of electrostatic powder evenly adsorbed on the surface of the workpiece to form a powder coating

powder coating baked at high temperatures leveling solidified into varying results (the effect of different types of powder coatings) final coating.
This product is widely used in the home appliances, hardware, security door (window), fins, architectural, auto parts, sports equipment

medical equipment, aluminum and other industries.

Operating Instruction:

  • Connect all the connecting lines and air tubes.
  • Turn on switch of power supply (lighting indicator is on).
  • Press the switch of spray gun to adjust voltage required (set by individual, voltage recommended is 60KV-80KV).
  • Powder is placed into powder feeding barrel.
  • Press the switch of spray gun and adjust to high-voltage. Start work if the powder is sprayed.

    Check the following conditions if the air pressure is not enough:

  • Whether the air pressure in compressor is more than 6kg.
  • Whether there is a leakage in the air tubes.
  • Whether pressure regulating valves are in good condition. Generally the pressure regulating valves are easy to adjust, anticlockwise direction to the end (off)
  • or clockwise direction to the end (maximum). Do not regulate them violently. If the pressure can’t be adjusted to a higher level.
  • the equipment will not be used until relevant solutions are found and failures are repaired.


  • Power Voltage: AC110V/AC220V
  • Frequency: 50/60Hz
  • Sprying Rate: 550g/min.
  • Input Power: 40W
  • Electromagnetic Valve Control Power Voltage: DC 24V
  • Maximum Output Current: 200Ua
  • Input Air Pressure: 0-0.6Mpa
  • Output Air Pressure: 0-0.5Mpa
  • Max. Air Consumption: 13.2m3/H
  • Output Powder Volume: Max. 550g/Min
  • Output Power Voltage: 0-100kv
  • Polarity: Negative
  • Gun Weight: 480g
  • Length Of Gun Cable: 4m
  • Powder Hopper Volume: 45L
  • Size: 520*520*660mm
  • V/N Weight: 35kg/28kg
  • Powder Coating Applicable: All Kinds Of Powder Without The Metals

  • Previous:
  • Next:

  • Write your message here and send it to us